← About PHYS 252

Spring 2023 · Final project

Multi-Band Audio Equalizer — project brief


rxyan2@wm.edu

Design and Build a Multi-Band Audio Equalizer with LED Indicators
PHYS 252 Final Project

Objective

The goal of this project is to design and build a multi-band analog audio equalizer. It adjusts the frequency response of an input audio signal and gives visual feedback with LED indicators. The project shows your understanding of op-amps, passive components, analog filter design and LED circuits.

Project requirements

  • The audio equalizer must have at least three adjustable frequency bands out of the eight bands in the table.
  • Each frequency band must have a variable gain, controlled by a potentiometer.
  • The equalizer should accept and produce audio signals. To test the input and output, you can use different test signals and observe the waveforms on an oscilloscope.
  • Use three LED indicators of different colors for each frequency band. The brightness of each LED shows the gain level of its band.
Frequency ranges and values
Frequency bandFrequency values
Sub-bass20 to 60 Hz
Bass60 to 160 Hz
Low midrange160 to 320 Hz
Midrange320 Hz to 640 kHz
Upper midrange640 to 1280 Hz
Lower treble1280 to 2560 Hz
Middle treble2560 to 5120 Hz
Upper treble5120 to 10200 Hz

Testable quantitative goals

  • Frequency band accuracy. The center frequency of each band should be within ±10%\pm 10\% of its target value. The target values depend on the bands you choose. Test this by putting in test tones and observing the output on an oscilloscope.
  • Gain adjustment range. The gain of each frequency band should be adjustable from −12-12 dB to +12+12 dB, with at most ±1\pm 1 dB error. Test this by putting in a test tone of constant amplitude within each band, turning the potentiometer and measuring the output amplitude.
  • LED indicators. The three LEDs should be brightest at +12+12 dB, dimmest at −12-12 dB and at medium brightness when flat (00 dB).

Project deliverables

Phase 1

Complete the design by the end of lab time, 5:00 p.m. on April 25, 26 or 27. You may work alone or with one assigned partner. Submit the schematics with short descriptions and the BOM to Gradescope by 2:00 p.m. on May 1.

  • Circuit schematics. Complete circuit schematics for the audio equalizer, including the band-pass filters, gain adjustment stages, input and output buffers, and LED indicators. Design and simulate the circuit with Multisim.
  • Bill of materials (BOM). A list of all components used in the project, including op-amps, resistors, capacitors, potentiometers, connectors and LEDs. No purchase orders are allowed.

Phase 2

Build the prototype and get results by the end of lab time, 5:00 p.m. on May 2, 3 or 4. You must do this part on your own. An instructor grades the results of each student and signs the provided sheet.

  • Breadboard prototype. A working prototype of the audio equalizer, built on a breadboard.
  • Test results. Documentation of the test results for each quantitative goal, including the relevant measurements, graphs or oscilloscope screenshots. Due by the end of lab time, 5:00 p.m. on May 2, 3 or 4.

Phase 3

The report is due on Gradescope by 5:00 p.m. on May 9. You must do this part on your own. You may not go back to the lab to redo Phase 2.

Project report. A written report of at most 3 pages on the design process, component selection, filter design, testing method and test results. Also discuss the problems you met during the project and the improvements you would make in a future version.

← Past final projects