← About PHYS 252

Spring 2025 · Final project

MixSense — project brief


rxyan2@wm.edu

Project Overview
Final Project 2025: MixSense

Objective

Design, simulate and build a stereo audio mixer that combines two stereo audio sources: background music and a vocal track. The mixer must have its own volume control for each input, a 2-band tone control (bass and treble), and three signal status LEDs that show channel presence and active mixing.

Context and testing setup

You will simulate your circuit in Multisim and test each of the four channels (L1, R1, L2, R2) with a function generator. This lets you check the frequency response, the mixing and the LED switching under controlled conditions. For the final demonstration we will use these two inputs (we can provide the soundtracks):

  • Input 1: background music (stereo) from source 1, such as a laptop.
  • Input 2: spoken audio (stereo), such as a podcast or movie clip, from source 2, such as a phone.

Use oscilloscopes throughout the build to check the signal behavior, the frequency shaping and the output quality.

To demonstrate your working prototype, we will connect speakers to your circuit output, so we can hear the result of your mixing and tone control.

To keep things realistic, all mixing and signal processing is done with LM358P dual op-amp ICs. Use them for the mixer, tone control and LED indicator stages.

Functional requirements

Inputs and volume control

  • Two stereo audio inputs (L and R for each source).
  • One potentiometer per input (music and vocal) for volume control.
  • The volume range must show about ±12\pm 12 dB of attenuation or gain.

Mixer and tone control

  • Mix the left and right signals separately.
  • Apply a 2-band active tone control (bass and treble) to the mixed outputs.
  • Each band must be adjustable and must clearly change the output frequency response:
    • Bass center frequency: about 100 Hz (range 80 to 150 Hz).
    • Treble center frequency: about 10 kHz (range 7 to 15 kHz).

LED indicators

  • Green LED: ON when the Input 1 (music) signal is present after the volume pot.
  • Blue LED: ON when the Input 2 (vocal) signal is present after the volume pot.
  • Red LED: ON only when both the green and blue LEDs are ON (both signals are active and being mixed).
  • The green and blue LEDs must turn OFF when the volume is zero or the input is silent.

Materials provided

  • LM358P dual op-amp ICs (5 per student)
  • 3.5 mm stereo jack cables and breadboard adapters
  • Various potentiometers for volume and tone
  • Passive components (resistors, capacitors) and jumper wires
  • Breadboards and ±9\pm 9 V power supplies
  • Access to audio test speakers and oscilloscopes

Timeline

  • Week 1: design with your partner, and simulate in Multisim.
  • Week 2: build on your own, test, and give a live demo.

Deliverables

  • Design plan (Week 1): 2 pages. Include the Multisim schematic and the expected function. Submit to Gradescope by 2:00 p.m. on April 28.

  • Final report (Week 2): at least 2 pages, at most 3 pages. It must include:

    • the final schematic and photos of your actual build;
    • what worked, what did not, and why;
    • quantitative measurements (gain, frequency response);
    • suggested improvements;
    • format: 0.5-inch margins, font size 10 to 11, single line spacing with 6 pt after each paragraph.

    Submit to Gradescope by 5:00 p.m. on May 13 if you are not graduating. If you are graduating, submit by 5:00 p.m. on May 5.

← Past final projects